v25 Azul Florentino
Zenza v25 Azul Florentino – Glass Mosaic Pool TileAn innovative Collection of glass mosaic tiles finely wrought to reproduce the matte texture of marble, the natural look of limestone and a finish reminiscent of sandstone, highlighted by veining in an attractive spectrum of colors that accentuates the design of each piece, and imbues any environment with warmth, distinction and comfort.
Tile Thickness: [tile_thickness]
Relative Pricing: [relative_pricing]
Shade Variation: [shade_variation]
Size: [title_size] [size_inch]
Sheet Size: [sheet_size]
No, mosaico veneciano® is usually attached to paper, mesh, plastic or dot, presented on 1/10 m2 sheets, 10 sheets making up 1m2, and generally packed in boxes of 4m2.
Owing to the fact that Kolorines® mosaic is made of glass it has traditionally been used for exteriors, whether for swimming pools where a covering is needed that withstands not only the application of highly corrosive chemicals such as chlorine, soda ash and muriatic acid (these last two are used to balance the pH), but also sunlight, discoloration and scrubbing on areas at the waterline where suntan lotions, oils etc. will stain any covering. As Kolorines® mosaic does not absorb water and therefore resists freezing in extreme climate conditions, it is also used in different types of weather and on façades where a low-maintenance covering unsusceptible to color loss is required. All these characteristics make this an ideal product for exteriors, although 50% of its good performance depends on correct installation both in exteriors and interiors. A common interior application during the Roman era was in the private baths of luxury residences and also in public baths, to which were added ornamental borders, medallions and artistic decoration.
No, because mosaico veneciano® is adhered to paper and the adhesive is soluble in water. Therefore under no circumstances should boxes be left outside where there may be extreme humidity or where they could get wet and run the risk of the glass tesserae coming off the paper.
They can be sent to the factory to be reattached or, if you are able to obtain the molds or trays and the adhesive paper, you can fix them back on yourself.
All our products are heat resistant and can be used around the fireplace. When covering an area in any high temperature environment you must first make sure that the adhesive and grout are made of heat resistant material.
Although laying is not difficult, experience in the correct method of installation is recommended for achieving optimum results. We advise you to take a preliminary course and to follow the manufacturer's instructions and recommendations.